Clinical Evaluation of Full Contour Zirconia Chairside CAD/CAM Crowns

After cavity preparation, the zirconia chairside crown will be placed using SpeedCEM Plus. The excess will be light cured with Bluephase G4 in PreCure mode (950 mW/cm\^2). After removal of the excess, the luting material margins will be light-cured again for 20s (1200 mW/cm\^2).

After cavity preparation, the zirconia chairside crown will be placed using ZirCAD Cement. The excess cement will be removed in the gel phase, either following light curing (5 - 10 seconds per segment) or following self-curing (approximately 2 min after placement). The restoration will be held in position during final curing that is complete 4 min 30 s after placement.