Effectiveness of Negative-Pressure Wound Therapy

The wounds were initially evaluated for any necrotic findings and debrided if needed, and then washed with an antiseptic solution. 3-DWM was used to measure the pressure sores by taking pictures.The length and width of wounds were measured with disposable paper rulers. Wound depth was determined in centimeters with a sterile cotton-tip applicator by measuring against a ruler. The wound was closed using a Wound Care Kit that includes foam dressing, film drape, TRAC pad with tubing and a drainage canister. Foam material was placed inside the wound and was attached to the canister through tubing.The canister was attached to the Vacuum-Assisted Closure device, which is a portable device that applies intermittent or continuous negative pressure.The device was operated at 125 mmHg pressure for 5 minutes with and 2 minutes without active vacuum.Wound dressings were changed every 48 hours.Wound area was measured after all three rounds of treatment.

Wounds were finally covered with gauze dressing soaked with saline. Wounds were treated three times a day, and measurements were repeated every 48 hours. Every wound was measured a total of four times: one pre-treatment (baseline) and three post-treatment measurements.