Effects of Spinal Manipulation on Vertebrobasilar and Internal Carotis Arteries in Healthy Population

GE LOGIQ S8 ultrasound machine was used to measure blood flow parameters in right and left a. carotis communis, a. carotis interna and a. vertebralis. All vessels were examined in the axial plane through their traces in the B-mode with a C6-15 MHz curvilinear matrix probe. Flow patterns and directions of vessels were then examined with Colour Doppler and it was determined whether there was any stenosis. Intimal thickness of a. carotis communis was measured by spectral doppler method. Measurements were recorded by visualizing the CCA at the supraclavicular level, the ICA carotid sinus (C4 level), and the VA at the V2 segment (C3-4 level), with less angle at 60 degrees. All measurements before and after the application were made at the same level. Immediately after manipulation, blood flow parameters were recorded as numerical data by the same physician again with Doppler USG of the relevant arteries.

"Manipulation procedures were applied to C1 or C2 (atlas and axis) vertebrae once in each participant. The application to which vertebrae were applied was determined by the palpation method applied by the physiotherapist. Manual chiropractic manipulation for C1 vertebra was applied in sitting position, using the digit / atlas pull technique. This technique is applied with the contact of practitioner's middle finger to the posterior part of transverse process of atlas, and generate a rotation force between C1 and C2 vertebrae.~The procedure was applied to C2 vertebra using the index / facet push technique in the supine position. This technique places pushing force in the direction of rotation between the C2-C3 vertebrae, placing the practitioner's index finger in contact with the posterior surface of the C2 facet joint."

"Activator technique was applied to C1 or C2 (atlas and axis) vertebrae once in each participant. The application to which vertebrae were applied was determined by the palpation method applied by the physiotherapist. Instrumental spinal manipulation was applied with Activator V chiropractic instrument. For C1 vertebra, the procedure was applied in supine position, by placing the Activator device horizontally on the participant's atlas transverse process of the affected side and applying a pushing force in the medial direction.~For C2 vertebra, the procedure was applied in prone position, by placing the Activator device in the relevant C2 pedicle-lamina junction of the participant's affected side and applying a pushing force in the anterior, superior and mild medial direction of movement of the facet joint."